Forget about porosity, high consumptions and
waste treatments

Ready To Use formulations refer to our range of Super concentrated release agents and Water free release agents, ready to be applied directly through conventional or special die heads.

This technology increases productivity and reduces consumption in the casting of complex parts (engine blocks, structural parts) and in the use of new Aluminum and Magnesium alloys.

Designed for:

BENEFITS

COMPARISON OF DIFFERENT TYPES OF RELEASE AGENTS PARAMETERS

Technical comparisons of the different formulations

01. TEMPERATURE AND DIE LIFE

The Ready To Use technology allows film generation at high die temperatures, above 300 – 320°C, as the Leidenfrost effect does not exist.

With less thermal shock, the lifetime of the die is increased. Release agents with Ready To Use technology do not provide cooling and the mold temperature does not drop drastically, avoiding the appearance of cracks on the surface due to shrinkage/expansion.

DIE COOLING – THERMAL SHOCK

2. DIE LUBRICATION

Our technical solutions with Ready To Use technology have a higher adhesion capacity to the mold.

FILM FORMATION

3. PARTS RESULTS

When working with Ready To Use technologies, the amount of product applied is less than usual, its lubrication capacity is greater and therefore the probability of suffering welding problems is reduced.

FRICTION RESISTANCE

Success Cases

Better finishes, less clogging and higher productivity


Application: High Pressure Die Casting

Solution: CASTFLOW 9000


MORE INFO

Recirculation systems with no contamination


Application: High Pressure Die Casting

Solution: CASTFLOW 8058


MORE INFO

Flame-retardant and protective hydraulic fluids


Application: High Pressure Die Casting

Solution: HYDROFLOW HFC 46


MORE INFO
WordPress Image Lightbox
WordPress Image Lightbox